NordicTrack Cx 998 Elliptical English Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen wrenches, assembly requires a phillips screwdriver , two adjustable wrenches , a rubber mallet , and pliers . As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The second number is the quantity used in assembly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it is pre-assembled. M6 Washer M8 Split (64)-2 Washer (30)-4 M10 Split Washer (73)-2 M4 x 12mm 7.6mm Spacer M8 Jam Nut Round Head M4 x 16mm (109)-2 (86)-9 Screw (96)-1 Screw (98)-2 M4 x 16mm Round Head M6 x 16mm Patch Screw (69)-4 Screw (76)-4 M8 x 41mm Button Bolt (85)-4 M8 x 56mm Button Screw (83)-4 M8 x 44mm Button Screw (84)-8 M8 x 79mm Bolt Set (65)-2 M8 x 38mm Button Bolt (105)-2 M10 x 108mm Button Screw (70)-2 1. Identify the Front Stabilizer (8). While another person lifts the front of the Frame (1) and holds the Pedal 1 Legs (4, 5) in the position shown, attach the Front 1 Stabilizer to the Frame with four M8 x 44mm Button 4, 5 Screws (84) and a Support Plate (104). While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (not shown) to the Frame in the same way. 8 104 84 84 5