NordicTrack Cxt 1100 Elliptical Uk Manual - Page 5

ASSEMBLY Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included hex keys and your own phillips screwdriver , adjustable spanner , rubber mallet , and pliers . As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 25. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled. M8 x 19mm Button M10 x 25mm Button M8 Split M10 Split M8 Washer Screw (30)-4 Screw (109)-3 Washer (58)-4 Washer (22)-11 (33)-4 M10 Washer (63)-2 M10 x 43mm Button Screw (65)-4 M10 x 56mm Button Screw (60)-4 M10 x 36mm Carriage Bolt (61)-2 1. Identify the Rear Stabiliser (59), which has Levelling Feet (14) threaded into it. Attach the Rear Stabiliser to 1 the Frame (1) with the four M10 x 56mm Button Screws (60) and four M10 Split Washers (22). 60 22 60 22 1 59 2. Attach the Front Stabiliser (90) to the Frame (1) with 2 the four M10 x 43mm Button Screws (65) and four M10 Split Washers (22). Make sure that the Front Stabiliser is turned so the Stabiliser Wheels (45) are not touching the floor. 65 22 45 14 65 22 1 90 5