NordicTrack E 4.0 Uk Manual - Page 25
Maintenance And Troubleshooting
View all NordicTrack E 4.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. 44 To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage 92 to the console, keep liquids away from the console and keep the console out of direct sunlight. 14 92 CONSOLE TROUBLESHOOTING If the handgrip heart rate monitor does not function 92 properly, see step 5 on page 19. HOW TO ADJUST THE DRIVE BELT 92 If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, you must remove the left pedal, the top shield cover, the rear shield cover, and the left shield (see the instructions below). Next, loosen the Pivot Screw (88). Then, tighten the Drive Belt Adjustment Screw (72) until the Drive Belt (46) is tight. First, unplug the power adapter. Then, see step 15 on page 13 and remove the left pedal. Next, see step 16 on page 14 and remove the rear shield cover. Then, see step 5 on page 8 and release the top shield cover from the shields. Slide the top shield cover 46 upward. Remove the M4 x 16mm Screws (92) from the Left Shield (44) and then gently move the Left Shield outward over the Left Pedal Arm (14). 88 72 When the Drive Belt (46) is tight, tighten the Pivot Screw (88). Then, reattach the left shield, the rear shield cover, the top shield cover, and the left pedal. Plug in the power adapter. 25