NordicTrack E 600 Elliptical Uk Manual - Page 11
Tip: Avoid pinching the Pulse Wire 28.
View all NordicTrack E 600 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
11. Have a second person hold the Handlebar (39) near the Upright (2). Locate the Pulse Wire (28) extending from the Handlebar, and route the Pulse Wire upward through the Upright as shown. Tip: Avoid pinching the Pulse Wire (28). Attach the Handlebar (39) to the Upright (2) with three M8 x 20mm Screws (62), three M8 Split Washers (64), and three M8 Small Washers (61); start all the Screws, and then tighten them. 11 39 62 64 61 Avoid pinching the Pulse Wire (28) 28 2 12. Attach the Handlebar Cover (7) to the Upright (2) with an M5 x 15mm Machine Screw (55). 12 7 55 2 13. While a second person holds the Console (4) near the Upright (2), plug the Upper Wire (42) 13 and the Pulse Wire (28) into the receptacles on the Console. The connectors on the Upper Wire and the Pulse Wire should slide easily into the receptacles and snap into place. If a connector does not slide easily into a receptacle, turn the connector and try again. If you do not connect the connectors properly, the Console may become damaged when you use the elliptical. Insert the excess wires into the Upright (2). Tip: Avoid pinching the wires. Attach the Console (4) to the Upright with four M4 x 16mm Screws (53); start all the Screws, and then tighten them. 4 28 Avoid pinching the wires 42 2 53 11