NordicTrack E 8.5 Elliptical Uk Manual - Page 18

If you purchase the optional heart rate monitor (see page 26), follow the additional step below to install the receiver included with the heart rate monitor. 25. See step 17. Remove the Front and Rear Leg Covers (29, 30, 31, 32) if necessary. 25 See steps 11 and 10. Remove the Front and Rear Upright Covers (25, 24) if necessary. Remove the paper from the adhesive pad on the back of the Receiver (A). Press the Receiver onto the indicated location on the inside of the Rear Upright Cover (24) below the Accessory Tray (26). 93 See the inset drawing. Make sure that the antenna on the Receiver (A) is oriented so that it is in a horizontal position parallel to the floor. Connect the wire on the Receiver (A) to the Extension Wire (121). 121 A 26 Next, attach the Rear Upright Cover (24) to the Upright (5) with four M4 x 16mm Screws (93). 5 Then, see step 11 and attach the Front Upright Cover (25) if necessary. 24 Next, see step 17 and attach the Front and Rear Leg Covers (29, 30, 31, 32) if necessary. Note: If you are installing the receiver as part of the elliptical assembly, go to step 11 and continue assembly. Note: Discard any other wires that are included with the heart rate monitor. Antenna A 18