NordicTrack E 9.0 Z Elliptical Enc Manual - Page 31
Maintenance And Troubleshooting, How To Adjust The Reed Switch
View all NordicTrack E 9.0 Z Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Next, using a standard Regular maintenance is important for optimal screwdriver, remove performance and to reduce wear. Inspect and properly the left Disc (71). tighten all parts each time the elliptical is used. Replace any worn parts immediately. 71 To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING Note: For clarity, the left shield and the left disc ring are shown removed in the drawing below. If the console does not turn on, make sure that the power cord is fully plugged in. Locate the Reed Switch (38). Turn the Pulley (19) until a Magnet (43) is aligned with the Reed Switch. If lines appear in the console display, see HOW TO CHANGE CONSOLE SETTINGS on page 30 and adjust the contrast level of the display. 19 If the console does not display your heart rate when you hold the handgrip heart rate monitor, or if the displayed heart rate appears to be too high or too low, see step 5 on page 24. HOW TO CALIBRATE THE INCLINE SYSTEM If the incline system is not functioning properly, it may need to be calibrated. To calibrate the incline system, press and hold the Calorie Workouts button for several seconds until the test mode appears in the display. 38 43 101 Next, press the Calorie Workouts button again. Then, press the One Touch Ramp increase or decrease button to calibrate the incline system. The ramp will move upward and downward as it calibrates. When the ramp stops moving, the incline system is calibrated. Press the Calorie Workouts button repeatedly to exit the calibration mode. Loosen, but do not remove, the indicated M4 x 16mm Screw (101). Slide the Reed Switch (38) slightly closer to or away from the Magnet (43), and then retighten the Screw. Then, plug in the power cord, press the power switch to the reset position, and rock the Pulley (19) forward and backward just enough that the Magnet passes the Reed Switch repeatedly. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first press the power switch to the off position and unplug the power cord. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, press the power switch to the off position, unplug the power cord, and reattach the left disc. Then, plug in the power cord. 31