NordicTrack E7 Instruction Manual - Page 7

4. Apply a small amount of the included grease to the right Crank Arm (20) and to a 19mm Wave 4 Washer (66). Orient a Crank Arm Spacer (55) so that the flat end is facing away from the elliptical. Slide the Crank Arm Spacer and the 19mm Wave Washer (66) onto the right Crank Arm (20). Identify the Right Roller Arm (59), which is marked with a "Right" sticker, and orient it as shown. Slide the Right Roller Arm (59) onto the right Crank Arm (20). Attach the Right Roller Arm with an M8 x 19mm Patch Screw (82), an Axle Cover (53), and an M8 x 25mm Washer (98); to avoid breaking the Axle Cover, do not overtighten the Patch Screw. Repeat this step for the Left Roller Arm (not shown). 20 Grease 55 66 Flat 98 53 End 82 59 5. Identify the Right Pedal Bracket (64), which is marked with a "Right" sticker. 5 Apply a small amount of grease to the inside of the tube on the Right Roller Arm (59) and to the barrel of an M10 x 60mm Bolt (100). Attach the Right Pedal Bracket (64) to the Right Roller Arm (59) with the M10 x 60mm Bolt (100), an M10 Washer (95), and an M10 Locknut (92). Do not overtighten the Locknut; the Right Pedal Bracket must pivot freely. Repeat this step for the Left Pedal Bracket (48). 92 95 48 64 100 Grease 59 7