NordicTrack Gx 4.2 Pro Bike English Manual - Page 7
Orient the Upright 4 and the Shield Cover 7
 |
View all NordicTrack Gx 4.2 Pro Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Orient the Upright (4) and the Shield Cover (7) as shown. Slide the Shield Cover upward onto 3 the Upright. Have a second person hold the Upright (4) and the Shield Cover (7) near the front of the Frame (1). Locate the wire tie inside the Upright (4). Tie the lower end of the wire tie to the Main Wire Harness (58). Pull the other end of the wire tie upward until the Main Wire Harness (58) is routed through the Upright (4). 4 7 Wire Tie 58 1 4. Tip: Avoid pinching the wires. Slide the Upright (4) onto the Frame (1). Attach the Upright with four M10 x 15mm Screws (65) and four M10 Washers (31); start all four Screws, and then tighten them. Do not press the Shield Cover (7) into place yet. 4 Avoid pinching 4 the wires 7 65 31 65 31 1 7
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
7
3.
Orient the Upright (4) and the Shield Cover (7)
as shown. Slide the Shield Cover upward onto
the Upright.
Have a second person hold the Upright (4)
and the Shield Cover (7) near the front of the
Frame (1).
Locate the wire tie inside the Upright (4). Tie
the lower end of the wire tie to the Main Wire
Harness (58).
Pull the other end of the wire tie upward until the
Main Wire Harness (58) is routed through the
Upright (4).
4.
Tip: Avoid pinching the wires.
Slide the
Upright (4) onto the Frame (1). Attach the
Upright with four M10 x 15mm Screws (65) and
four M10 Washers (31);
start all four Screws,
and then tighten them.
Do not press the Shield Cover (7) into place
yet.
3
4
4
4
1
7
7
58
1
65
65
31
31
Wire Tie
Avoid pinching
the wires