NordicTrack Rx 800 Instruction Manual - Page 16

MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the rower is used. Replace any worn parts immediately. To clean the rower, use a damp cloth and a small amount of mild detergent. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. For best results, clean the rail, the seat carriage, and the carriage rollers daily. CONSOLE TROUBLESHOOTING Most console problems are the result of low batteries; for replacement instructions, see assembly step 8 on page 8. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must remove the resistance handle and the right and left shields as described below. First, remove the six M4 x 10mm Screws (70), and then gently remove 70 the Resistance Handle (9). 9 70 See the EXPLODED DRAWING on page 19. Locate the Right and Left Shields (7, 8). Remove the four M4 x 19mm Screws (69) and the ten M4 x 16mm Screws (68) from the Right and Left Shields. Then, gently remove the Right and Left Shields. Next, locate the Reed Switch (47). Turn the Left Fan (4) until a Magnet (85) is aligned with the Reed Switch. Slightly loosen the two indicated M4 x 19mm Screws (69). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screws. 47 4 85 69 Turn the Left Fan (4) so that the Magnet (85) passes the Reed Switch (47) repeatedly. Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the parts that you removed. 16