NordicTrack Spacesaver Se5i Elliptical English Manual - Page 19

HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. To adjust the drive belt, first unplug the power adapter. Next, remove the indicated M4 x 16mm Screw (61), the Left Leg Inner Cover (39), and the Left Leg Outer Cover (92). the Large Storage Foot. Remove the two M4 x 16mm Screws (not shown) from the Top Shield (37), and then use a standard screwdriver to pry the Top Shield upward off the elliptical. Then, pry the left Pedal Disc (26) off the elliptical. See EXPLODED DRAWING C on page 27. Identify the Left and Right Shields (44, 45). Remove all of the M4 x 16mm Screws (61) and 3/16" x 1 3/8" Screws (64) from the Left and Right Shields. Make sure to note which size Screws come from which holes. Then, carefully remove the Left Shield. Loosen the Idler Screw (97). Tighten the Idler Adjustment Screw (72) until the Drive Belt (46) is tight. When the Drive Belt is tight, retighten the Idler Screw. 101 39 92 76 33 61 76 33 14 Then, remove the two M8 x 16mm Screws (76) and the two M8 Washers (33) from the Left Upper Body Leg (101) and the Left Pedal Arm (14). Next, remove the M8 x 14mm Shoulder Screw (81) from the Left Pedal Arm (14). Remove the Left Pedal Arm from the elliptical. 14 81 37 27 46 97 72 When you are finished, reattach the parts that you removed. Then, plug in the power adapter. 26 Remove the four M4 x 16mm Screws (not shown) from the Large Storage Foot (27), and then remove 19