NordicTrack T15.0 Treadmill English Manual - Page 7
Assembly
View all NordicTrack T15.0 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 6. • Assembly requires the following tools: the included hex keys one adjustable wrench one Phillips screwdriver To avoid damaging parts, do not use power tools. 1. Make sure that the power cord is unplugged. 1 Place a piece of cardboard below the rear of the Frame (56) to protect the floor or carpet. Attach the Left Wheel Cap (96) to the Base (94) with two #8 x 3/4" Screws (2). Attach the Right Wheel Cap (not shown) to the right side of the Base (94) in the same way. 94 2 56 96 Cardboard 2. Pull the Upright Wire (81) and the base ground wire (A) through the indicated hole in the Base 2 (94). Attach the base ground wire (A) to the Base (94) with a #8 x 1/2" Ground Screw (10). Press the Grommet (77) into the square hole in the Base (94). 77 Hole 81 10 A 94 7