NordicTrack Walkfit 5000 Owners Guide - Page 6
Assembly
View all NordicTrack Walkfit 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Assembly Six Ouick Assembly Steps 1. Attach the front-elevation legs and lock them into place with the two easy-lock pins. 2. Position the upper-body exerciser over the front of the treadmill base and secure it with the four Allen bolts. 3. Connect the tension spring (below the upper-body exerciser) to the tension rod underneath the front of the treadmill deck. 4. Snap the sensor cord (below the upper-body exerciser) to the underside receptacle. 5. Attach the hip pad to the upright tube. 6. Install the workout computer. Attach the Front-Elevation Legs 1. Remove the elevation legs and the two easy-lock pins from Box 2. 2. Tilt the treadmill base to one side. There should be enough clearance to slide an elevation leg into the sleeve at the front of the treadmill deck (Figure 1). 4. Align the holes in the leg and the sleeve. Insert. the straight end of an easy-lock pin completely through the holes (Figure 2). Be sure the pin extends through 1 both sides of the front-elevation leg and sleeve. I Sleeve Easy-lock pin Figure 2 Elevation leg 5. Rotate the bent side of the easy-lock pin down to secure it in place (Figure 3). Sleeve Elevation leg Figure 1 3. Place an elevation leg into a sleeve. Be sure the holes in the elevation leg are facing the same direction as those in the sleeve. Figure 3