Oki B8300n Guide: User's, B8300 - Page 67
Loading paper in the bypass tray
View all Oki B8300n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Loading paper in the bypass tray The bypass tray can be used for plain paper and special papers including labels. Up to 100 sheets of standard paper can be set. If the paper type or size is changed, be sure to enter the paper type and size as in step 4. 1. Open the bypass tray. NOTES • When using A5, 5½" x 8½" paper or postcards, be sure to load them with their shorter edge into the feed slot as shown in the illustration below. Bypass tray extension When setting 11"x 17", 8½" x 14", 8½" x 13, A3 or B4 paper, be sure to extend the bypass tray extension. 2. Set the bypass tray paper guides to the width of the paper to be used. • When using special paper, postcards or transparency film, be sure to feed them one sheet at a time. If you set more than one sheet, a paper misfeed may occur. • When adding paper, first remove remaining paper, combine it with the paper to be added, and then reload as a single stack. Adding paper without stacking it correctly may cause a paper misfeed. • When printing on to transparency film, remove the output sheets as soon as possible. • For transparency film, use Oki recommended film. 3. Insert the paper all the way into the bypass tray. Set the paper face down. If there is a clearance between the paper and the paper guides, the paper may not be fed correctly. Adjust the guides so that they contact the edges of the paper. 4. Use the opertor panel to set the type and size of loaded paper. When the paper system is changed from the inch system to the AB system or vise versa or when the paper type is changed, the paper type must be designated. 5. Loading paper in the bypass tray is now complete. Duplex module - 66