Oki B8300n Guide: Installation B8300 - Page 3

B83MP Installation Manual FOR USE WITH COMPATIBLE OKI DIGITAL PRINTERS. SEE OKI DIGITAL PRINTER SERVICE MANUAL OR INSTALLATION MANUAL TO DETERMINE SUITABILITY. When installing a finisher or a mail-bin stacker with B83MP, a power supply unit is needed. Front mounting plates: 2 pcs. Rear mounting plates: 2 pcs. Screws (M4x8): 4 pcs. 1. Turn off the main switch of the main unit of the printer. Turn the main switch located on the front side of the main unit to the "OFF" position. Then, remove the power plug of the main unit from the outlet. "OFF" 2. Put the main unit of the printer on the multi purpose drawer. Pull out the paper tray of the main unit until it stops and then remove it by lifting both ends of the tray. 3. Connect the main unit of the printer to the multi purpose drawer. Attach the two rear mounting plates using a supplied screw for each. Rear mounting plate 4. Connect the harness to the main unit of the printer. Remove the screw that fixes the harness cover of the main unit of the printer and then slide the harness cover up to remove it. Screw Screw Rear mounting plate [Caution] Insert the mounting plate under the tray frame. Screw Mounting plate Tray frame Pull out the multi purpose drawer until it stops and attach the two front mounting plates using a supplied screw for each. Then, remove the lock of the paper tray and close the tray. Cut out. Harness cover * Cut out the harness cover as shown in the illustration. Connect the connector of the relay harness of the multi purpose drawer to CN10 (blue connector) of the PCU PWB of the main unit of the printer. CN10 Connector Front mounting plate Screw 2 * If another peripheral device must be installed, carry out the following step at the end of the installation work. 6. Adjust the position of the paper guides of the paper tray. To use the setting mode, insert the power plug of the main unit of the printer to the outlet and turn the main switch on while pressing the [MENU] key and the [OK] key of the operation panel of the main unit of the printer. Press the [MENU] key several times to display "SIZE ADJUSTMENT A" and press the [OK] key. "MAXIMUM SIZE" is displayed. Pull out the paper tray and extend the paper guides to the maximum. Then, return the paper tray into the main unit and press the [OK] key. "MINIMUM SIZE" is displayed. Pull out the paper tray again and narrow the paper guides to the minimum. Then, return the paper tray into the main unit and press the [OK] key. Press the [BACK / CLEAR] key to exit the setting mode. [Caution] If the setting above is not carried out, the paper detection function will not operate. Rear guide Hold the main unit of the printer at the positions shown in the illustration and put the main unit on the multi purpose drawer so that the front side and the left side of the main unit are aligned to those of the multi purpose drawer. Front side For installation of a finisher or a mail-bin stacker, see its installation manual. Screw Front mounting plate 5. Attach the harness cover. Reattach the harness cover to its original position and fix it with the removed screw. Screw Reattach the paper tray of the main unit of the printer. Paper guide 7. Carry out the off center adjustment. Installation is now complete. Rear side [Caution] For installation of the main unit, it must be held by two persons and installed carefully. Harness cover Wire saddle Wire saddle * Fix the harness securely to the wire saddle.