Oki C9600hnColorSignage C9600 Network and Configuration Guide - Page 215
Troubleshooting, EtherTalk
View all Oki C9600hnColorSignage manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
Troubleshooting: EtherTalk Not identified by the Chooser and the Setup Utility. • Turn the printer off and on again. • Make sure the network cable is correctly connected. • Change the cable and try again. • If the network resides in a Zone, make sure the correct Zone name is selected in the Chooser. • Make sure the Zone name in the utility related to the NIC is the same as the Zone name set in NIC. • Make sure AppleTalk, which is displayed at the right bottom of the Chooser, is set to Enable. (In some OS versions Network is used instead of AppleTalk.) • Make sure Ethernet is selected in AppleTalk. (In some OS versions Network is used instead of AppleTalk.) • Make sure the print driver is selected in the Chooser. • Make sure the EtherTalk protocol is set to Enable. • Print the NIC settings (see page 12) and confirm that the EtherTalk Port name is not blank. Troubleshooting: EtherTalk • 215