Oki MICROLINE 390 TURBO OkiLAN 6020e? Pocket Print Server Userfs Guide - Page 115
Enabling/Disabling Protocols, SNMP Trap Configuration, format XXX.XXX.XXX.XXX, where each XXX is
View all Oki MICROLINE 390 TURBO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Section 4 - Chapter 4 - OkiNet for TCP/IP Trap Destination • TCP/IP Protocol - Enter the IP address to which traps will be sent. The IP address must follow the format XXX.XXX.XXX.XXX, where each XXX is a number from 0 to 255. To broadcast traps to all hosts on the local subnet, enter 255.255.255.255. • NetWare Protocol - Enter the network number and hardware address, respectively, to which traps will be sent. To broadcast traps to all addresses on all networks, enter FFFFFFFF (8 characters) in the first field and FFFFFFFFFFFF (12 characters) in the second field. To broadcast traps to all addresses on a specific network, enter the network number in the first field and then FFFFFFFFFFFF (12 characters) in the second field. Ports to Trap Select the output ports on which you wish traps to be active. Printer Traps Select the printer traps to be activated. The following printer error conditions may cause a printer trap to occur: • On-line • Off-line • No Printer Attached • Paper Out • Paper Jam • Door Open • Toner Low • Printer Error The toner low, door open and paper jam traps require that your printer be set to automatic emulation switching (the default) or PCL emulation. TCP/IP OKI OkiLAN 6020e User's Guide IV - 33