Oki OKIPOS 407II USBBlack Users Guide - Page 21

Attaching the Accessories

Get Oki OKIPOS 407II USBBlack PDF manuals and user guides View all Oki OKIPOS 407II USBBlack manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

4. Attaching the Accessories The following accessories do not necessarily have to be attached. Attach them if necessary. • Holding plate • Cable cover • Switch blind 4-1. Attaching the Holder Plate Shaft (1) Attach the shaft to the printer. Push in the left and right ends of the shaft. (2) Wipe the area into which the rubber feet will be affixed in order to remove any grime; then, affix the roll stoppers. The positions for affixing them will vary depending on the paper width. 82.5 or 79.5 mm width 57.5 mm width (3) Use a regular screwdriver to remove the clips at both ends of the bar to remove the tension bar unit. - 17 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
– ±¶ –
4. Attaching the Accessories
The following accessories do not necessarily have to be attached.
Attach them if necessary.
• Holding plate
• Cable cover
• Switch blind
Shaft
82.5 or 79.5 mm width
57.5 mm width
4-1.
Attaching the Holder Plate
(±) Attach the shaft to the printer.
(2)
Wipe the area into which the rubber feet will be affixed in order to remove any grime; then,
affix the roll stoppers. The positions for affixing them will vary depending on the paper
width.
(³) Use a regular screwdriver to remove the clips at
both ends of the bar to remove the tension bar
unit.
Push in the left and
right ends of the shaft.