Olympus FE 300 FE-300 Instruction Manual (English) - Page 48
Select [MEMORY FORMAT] - problems
View all Olympus FE 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
When you get an error message on the camera... Getting to know your camera better 48 EN Monitor indication q CARD ERROR q WRITE PROTECT > MEMORY FULL q CARD FULL L NO PICTURE r PICTURE ERROR r THE IMAGE CANNOT BE EDITED CARD-COVER OPEN g BATTERY EMPTY CARD SETUP xD CARD CLEAN FORMAT SET OK MEMORY SETUP POWER OFF MEMORY FORMAT SET OK NO CONNECTION NO PAPER NO INK Possible cause There is a problem with the card. Corrective action This card cannot be used. Insert a new card. Writing to the card is prohibited. The internal memory has no available memory and cannot store any new data. The card has no available memory and cannot store any new data. There are no pictures in the internal memory or on the card. There is a problem with the selected picture and it cannot be played back on this camera. Pictures taken by other cameras or previously edited or corrected pictures cannot be edited or fixed. The recorded image has been protected (read-only) on a computer. Download the image to a computer and cancel the readonly setting. Insert a card or erase unwanted data. Before erasing, backup the data of important pictures using the card, or download such pictures to a computer. Replace the card or erase unwanted data. Before erasing, download important pictures to a computer. The internal memory or the card contains no pictures. Record pictures. Use image processing software to view the picture on a computer. If that cannot be done, the image file is damaged. Use image processing software to edit the pictures. The battery/card Close the battery/card compartment cover. compartment cover is open. The battery is empty. Charge the battery. The data in the card cannot be read. Or, the card is not formatted. There is an error in the internal memory. • Select [xD CARD CLEAN], and press . Remove the card and wipe the contact area with a soft dry cloth. • Select [FORMAT] [YES] and press . All data on the card is erased. Select [MEMORY FORMAT] [YES] and press . All data in the internal memory is erased. The camera is not connected to the computer or the printer correctly. There is no paper in the printer. Disconnect the camera and connect it again correctly. Load some paper into the printer. The printer has run out of ink. Replace the ink cartridge in the printer.