Olympus PT-E06 PT-E06 Underwater Housing for the E-620 DSLR Instruction Manual - Page 25
Replace consumable products, Maintenance of the threaded s on the TTL cable and TTL, cable
UPC - 050332168954
View all Olympus PT-E06 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Replace consumable products • The O-ring is a consumable product. Independent of the number of times the Case is used, it is recommended that the O-ring should be replaced by a new piece at least once a year. • Deterioration of the O-ring is accelerated by the usage conditions and the storage conditions. Replace the O-ring even before a year has passed if it shows signs of damage, cracking or loss of elasticity. CAUTION: • Please use genuine Olympus silicone grease, silica gel and O-ring. • Do not try to replace the O-ring by yourself. • We recommend to perform the check periodically. Maintenance of the threaded sections on the TTL cable and TTL cable connector If the threaded sections used to connect the TTL cable to the TTL cable connector are not maintained properly, salt and other seawater residue may adhere to the TTL cable and prevent it from being disconnected. After use in seawater, clean off any salt, sand, or other residue as soon as possible, then dry the equipment thoroughly. Clean the threaded sections with a cotton swab and apply a thin, uniform layer of silicone grease (provided with this case). Clean and apply silicone grease to these sections. Maintenance of the TTL Connector Cap After removing the TTL connector cap from the Underwater Case, be sure to clean and grease the Oring. Use the maintenance adapter to remove the O-ring unit from the TTL connector cap. TTL connector cap Maintenance adapter En 1 Insert the adapter by aligning its pin with the hole on the cap. 2 Turn the adapter counterclockwise to remove the Oring unit. 3 After removing the O-ring attached to the O-ring unit, clean the O-ring groove and apply silicone grease to the O-ring. Then, re-attach the O-ring to the O-ring unit. * Reverse the removal procedure to re-attach the O-ring unit to the TTL connector cap. O-ring EN 24