Olympus Tough 6000 STYLUS TOUGH-6000 Instruction Manual (English) - Page 56

Usage Tips If the camera does not work as intended, or if an error message is displayed on the screen, and you are unsure of what to do, refer to the information below to fix the problem(s). Troubleshooting Monitor "Difficult to see" ● Condensation*1 may have formed. Turn off the power and wait for the camera body to become acclimated to the surrounding temperature and dry out before taking pictures. *1 Dew drops can form in the camera when it is suddenly taken from a cold location into a warm, humid room. Battery "The camera does not work even when battery is installed" ● Insert recharged battery in the correct direction. "Charging the battery" (p. 10), "Loading the battery and the xD-Picture Card™ (sold separately) into the camera" (p. 11) ● Battery performance may have been reduced temporarily due to low temperature. Take the battery out of the camera, and warm it by putting it in your pocket for a while. "Vertical lines appear on the screen" ● Vertical lines may appear on the screen at times such as when the camera is pointed at an extremely bright subject under a clear sky. The lines do not appear, however, in the final image. "The light is caught in the picture" ● Shooting with flash in dark situations results in an image with many flash reflections on dust in the air. X Card/Internal memory "An error message is displayed" "Error message" (p. 57) Shutter button "No picture is taken when the shutter button is pressed" ● Cancel sleep mode. To save battery power, the camera automatically goes into sleep mode and the monitor turns off if there is no operation after 3 minutes when the camera is turned on. No picture is taken even if the shutter button is fully pressed in this mode. Operate the zoom button or other buttons to restore the camera from sleep mode before taking a picture. If the camera is left for 15 minutes, it automatically turns off. Press the n button to turn on the camera. ● Set the mode dial to a position other than q. ● Wait until #(flash charge) stops blinking before taking pictures. Date and time function Y M D TIME "Date and time settings re--t-u- r-n- -t-o--th--e Y M D default setting" ● If the battery is removed and CANCEL MENU left out of the camera for about 1 day*2, the date and time settings return to the default setting and must be reset. *2 The time until the date and time settings return to the default setting varies depending on how long the battery have been loaded. "Setting the date and time" (p. 13) Others "Noises occur from the inside of the camera in shooting standby mode" ● Auto focusing operation may cause lens movement noises even if you do not make any camera operation. 56 EN