Onkyo DV-CP701 Owner Manual - Page 46
The message NO
View all Onkyo DV-CP701 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Symptom Possible cause Remedy The message "NO PLAY" appears on the display? The disc is dirty. Remove the disc and clean it (page 8). Buttons on the DVCP701 and remote controller don't work? Power supply voltage fluctuations and other anomalies, such as static electricity, can interfere with normal operation. Turn off the DV-CP701, wait five seconds, then turn it on again. If that doesn't resolve the issue, disconnect the power cord from the wall outlet, wait five seconds, reconnect it, then try again. There are no batteries in the remote controller. Install new batteries (page 15). The batteries are flat. Replace with new batteries (page 15). The batteries are installed incorrectly. Check the batteries and correct as necessary (page 15). Buttons on the DVCP701 work OK but those on the remote controller don't? You're not pointing the remote controller at the DV-CP701's remote sensor. You're too far away from the DV-CP701. Point the remote controller at the DV-CP701's remote sensor (page 15). Use the remote controller closer to the DV-CP701 (page 15). The remote controller has a range of approximately 16 ft. (5 meters). A strong light source is interfering with the DV-CP701's remote sensor. Make sure that the DV-CP701 is not subjected to direct sunshine or inverter-type fluorescent lights. Relocate if necessary. If the DV-CP701 is installed in a cabinet with colored glass doors, the remote control- Open the doors, or use a cabinet without colored ler may not work reliably when the doors are glass. closed. ■ Abnormal Behavior The DV-CP701 contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Alternatively, press and hold the STOP [ ] button until "RESET" appears on the display (about 10 seconds). ■ Restoring the Default Settings To reset the DV-CP701 to its factory defaults, turn it on and, while holding down the STOP [ ] button, press the [STANDBY/ ON] button. "INITIALIZE" appears on the display. When the reset is complete, "COMPLETE" is displayed, and the DVCP701 enters Standby mode. 46