Onkyo HT-R510 Owner Manual - Page 4

Precautions-Continued 1. Recording Copyright-Unless it's for personal use only, recording copyrighted material is illegal without the permission of the copyright holder. 2. AC Fuse-The AC fuse inside the HT-R510 is not user-serviceable. If you cannot turn on the HT-R510, contact your Onkyo dealer. 3. Care-Occasionally you should dust the HT-R510 all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the HT-R510 immediately afterwards with a clean cloth. Don't use abrasive cloths, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering. 4. Power WARNING BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY. Supplied Accessories AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the HT-R510's rear panel (AC 120 V, 60 Hz). Setting the [STANDBY/ON] switch to STANDBY does not fully shutdown the HT-R510. If you do not intend to use the HT-R510 for an extended period, remove the power cord from the AC outlet. Memory backup The HT-R510 uses a battery-less memory backup system in order to retain radio presets and other settings when it's unplugged or in the case of a power failure. Although no batteries are required, the HT-R510 must be plugged into an AC outlet in order to charge the backup system. Once it has been charged, the HT-R510 will retain the settings for several weeks, although this depends on the environment and will be shorter in humid climates. Make sure you have the following accessories: Front Left Front Left SP-B / Zone 2 Left SP-B / Zone 2 Left Front Right Front Right SP-B / Zone 2 Right SP-B / Zone 2 Right Surround Left Surround Left Surround Right Surround Right Center Center Surround Back Left Surround Back Left Zone 2 Left Zone 2 Left Surround Back Right Surround Back Right Zone 2 Right Zone 2 Right Front Left Front Left SP-B / Zone 2 Left SP-B / Zone 2 Left Front Right Front Right SP-B / Zone 2 Right SP-B / Zone 2 Right Surround Left Surround Left Surround Right Surround Right Center Center Surround Back Left Surround Back Left Zone 2 Left Zone 2 Left Surround Back Right Surround Back Right Zone 2 Right Zone 2 Right 1 2 3 Speaker Cable AM loop antenna Indoor FM antenna Remote controller & two batteries (AA/R6) Speaker cable labels * In catalogs and on packaging, the letter added to the end of the product name indicates the color of the HT-R510. Specifications and operation are the same regardless of color. Features Amp • 6-channel amplifier • 100 watts per channel min. RMS at 8 Ω, 2 channels driven from 20 Hz to 20 kHz with no more than 0.08% total harmonic distortion • WRAT (Wide Range Amplifier Technology) • Optimum gain volume circuitry Audio/Video • Dolby*1 Digital EX and Dolby Pro Logic II • DTS, DTS-ES Matrix/Discrete 6.1, and DTS Neo:6 pro- cessing*2 • Cinema Filter function • Advanced 24-bit DSP chip (5 DSP soundfields) • Linear PCM 96 kHz/24-bit D/A converters on all channels • Adjustable crossover (60, 80, 100, 120, 150 Hz) • 2 component video inputs, 1 output • 4 S-Video inputs, 2 outputs • 3 assignable digital inputs (2 optical, 1 coaxial) • Subwoofer pre out • Color-coded multi-channel inputs • Color-coded speaker terminal posts (SPEAKERS B use push-type terminals) FM/AM Tuner • 30 FM/AM presets • FM auto tuning *1. Manufactured under license from Dolby Laboratories. "Dolby," "Pro Logic," Surround EX," and the double-D symbol are trademarks of Dolby Laboratories. *2. "DTS," "DTS-ES Extended Surround," and "Neo:6" are trademarks of Digital Theater Systems, Inc. 4