Onkyo TX NR906 Owner Manual - Page 103
Use the Down, select a speaker.
UPC - 751398008351
View all Onkyo TX NR906 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Advanced Setup-Continued 5 Use the Down [X] button to select "Channel", and then use the Left and Right [F]/[S] buttons to select a speaker. You can select: "Front", "Center", "Surround", "SurrBack", or "Sub- woofer". 2-5. Equalizer Settings Equalizer Channel 63Hz 160Hz 400Hz 1000Hz 2500Hz 6300Hz 16000Hz Manual Front 0dB 0dB 0dB 0dB 0dB 0dB 0dB MOVE VALUE RETURN RETURN SETUP EXIT 6 Use the Up and Down [R]/[X] but- tons to select a frequency, and then use the Left and Right [F]/[S] buttons to adjust the level at that frequency. You can select: "63Hz", "160Hz", "400Hz", "1000Hz", "2500Hz", "6300Hz", or "16000Hz". And for the subwoofer, "25Hz", "40Hz", "63Hz", "100Hz", or "160Hz". The volume at each frequency can be adjusted from -6 to +6 dB in 1 dB steps. Tip: Low frequencies (e.g., 160Hz) affect bass sounds; high frequencies (e.g., 6300Hz) affect treble sounds. 7 Use the Up and Down [R]/[X] but- tons to select "Channel", and then use the Left and Right [F]/[S] buttons to select another speaker. Repeat steps 6 and 7 for each speaker. • The Equalizer settings have no effect on 176.4/ 192 kHz input signals. • This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. 8 Press the [SETUP] button. The setup menu closes. Notes: • When the listening mode is set to Direct or Pure Audio, no effect will be produced. 103