Onkyo TX SR505 Owner Manual - Page 19

Connecting Your Speakers-Continued Connecting Speaker Set A 1 Strip 5/8" (15 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. 5/8" (15 mm) 2 Unscrew the terminal. Fully insert the bare wire, making sure that it's touching the threaded shaft in the center. Screw the terminal tight. Connecting a Powered Subwoofer Using a suitable cable, connect the AV receiver's SUBWOOFER PRE OUT to the input on your powered subwoofer. If your subwoofer is unpowered and you're using an external amplifier, connect the SUBWOOFER PRE OUT to it's input. Note: Make sure the plugs are pushed in all the way. Connecting Speaker Set B 1 Strip 3/8" (10 mm) of insulation from the ends of the speaker cables, and twist the bare wires tightly, as shown. 2 While pressing the lever, insert the wire into the hole, and then release the lever. Make sure that the terminals are gripping the bare wires, not the insulation. 3/8" (10 mm) Note: While speaker set B is on, speaker set A is reduced to 5.1-channel playback. Front right speaker Speaker Set A Front left speaker The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one surround back speaker, connect it to the left (L) SURROUND BACK SPEAKERS terminals. Center speaker ANTENNA AM FM 75 SURROUND BACK SPEAKERS L CBL/SAT V VCR/DVR S DVD MONITOR OUT V R S IN OUT IN IN IN OUT IN FRONT SURROUND CENTER SURR BACK L L R CBL/SAT VCR/DVR R SUB WOOFER DVD SURROUND SPEAKERS FRONT SPEAKERS A L CENTER SPEAKER R PRE OUT SUB WOOFER L R FRONT SPEAKERS B SURROUND BACK SPEAKERS L SURROUND SPEAKERS FRONT SPEAKERS A L CENTER SPEAKER R R Front right Front left speaker speaker Speaker Set B LINE INPUT Powered subwoofer Surround back right speaker Surround back left speaker Surround right speaker Surround left speaker 19