Onkyo TX SR505 Owner Manual - Page 79

ENTER TUNING STANDBY/ON STANDBY TUNING PRESET MASTER VOLUME PHONES MULTI CH A SPEAKERS B DVD VCR/DVR CBL/SAT AUX TAPE TUNER C D SETUP ENTER RETURN TONE STEREO LISTENING MODE DISPLAY DIGITAL INPUT DIMMER MEMORY TUNING MODE CLEAR SETUP MIC AUX INPUT VIDEO L AUDIO R SETUP Positioning the SiriusConnect Home tuner You can check the strength of the SIRIUS Satellite Radio signal and adjust the position of the SiriusConnect Home tuner accordingly. 1 On the AV receiver, press the [SETUP] button. SETUP 2 TUNING PRESET Use the TUNING Up and Down [ ]/[ ] buttons to select "ANT Aiming," and then press [ENTER]. SIRIUS Satellite Radio Messages The following messages may appear while using SIRIUS Satellite Radio. ❑ ACQUIRING The SiriusConnect receiver is acquiring the signal or no signal is present. Make sure the SiriusConnect Home tuner is connected properly and that there are no obstacles close by. ❑ ANTENNA ERROR Make sure the SiriusConnect Home tuner is connected properly. ❑ SUB UPDATED Displayed while your subscription is being updated. No operations can be performed until this message has cleared. ❑ UPDATING XXX% ENTER 3 Adjust the position of the SiriusConnect Home tuner so that the SAT signal strength bar is as long as possible. Displayed while the channel map is being updated. Wait until the updating is complete. ❑ UPDATING Displayed while the SiriusConnect receiver's firmware is being updated. ❑ INVALID CHANNEL If you cannot receive a satellite signal, press the Down [ ] button to display the terrestrial (TER) signal strength meter and adjust your antenna so that the bar is as long as possible. Terrestrial signals are only available in certain areas. So long as the signal strength is good, you can enjoy SIRIUS Satellite Radio by using either satellite or terrestrial reception. Displayed if you select an unavailable channel. ❑ CALL SIRIUS Displayed when you select a channel to which you are not subscribed. Call SIRIUS if you want to subscribe. ❑ CHECK SR TUNER Displayed if the SiriusConnect receiver is not connected. Make sure the SiriusConnect receiver is connected properly, and make sure its AC adapter is plugged in. 7