Onkyo TX SR804 Owner Manual - Page 4

Turning on & Using Automatic Speaker Setup With the supplied speaker setup microphone, use the Automatic Speaker Setup function. Before using this function, connect and position all your speakers. 1 Remote controller AV receiver STANDBY/ON RECEIVER or ON Press the [STANDBY/ON] button on the AV receiver or press the remote controller's [RECEIVER] button followed by the [ON] button to turn on the AV receiver. Turn on the TV and select the input to which the AV receiver is connected. 2 SETUP MIC ENTER 3 ENTER ENTER MIC position Put the speaker setup microphone in the listening position, and connect it to the SETUP MIC jack on the front panel. And press [ENTER]. The automatic speaker setup starts. The whole process takes about 2 minutes. Auto Speaker Setup Push Enter:Start Caution! Loud sound. Auto Speaker Setup Apply the Results Check the Results Retry Retry with Test noise Level up Cancel When you've finished the setup, press the Up and Down [ ]/[ ] buttons to select "Apply the Results," and then press [ENTER]. Disconnect the speaker setup microphone. Selecting the Input Source 1. Use the AV receiver's input selector buttons to select the input source. To select the input source with the remote controller, press the [RECEIVER] button, and then use the INPUT SELECTOR buttons. 2. Start playback. 3. To adjust the volume, use the MASTER VOL- UME control, or the remote controller's [VOL] button. SN 29344330 (C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved. 3 STANDBY/ON STANDBY ZONE 2 PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 TAPE TUNER CD PHONO DISPLAY MASTER VOLUME PUSH TO OPEN 1 I0609-1 * 2 9 3 4 4 3 3 0 *