Onkyo TXSR603B Owner Manual - Page 36

Connecting the AV Receiver-Continued Connecting Components With (Remote Interactive) you can control your -compatible Onkyo CD player, DVD player, and so on with the AV receiver's remote controller, as follows: • To use , you must make an analog audio con- nection between the AV receiver and the other AV components, even if they are connected digitally. Auto Power On/Standby When you start playback on an AV component connected via , if the AV receiver is in Standby, it will turn on and select that AV component as the input source automatically. Similarly, when the AV receiver is set to Standby, all components connected via also enter Standby. Note that this function will not work if the component's power cord is connected to the AV receiver's AC OUTLET. Direct Change When playback is started on an AV component connected via , the AV receiver automatically selects that AV component as the input source. Remote Control You can control your -compatible Onkyo components with the AV receiver's remote controller. IN L R IR IN DIGITAL COAXIAL IN 1 IN 2 OPTICAL IN 1 12 V TRIGGER OUT ZONE 2 COMPONENT VIDEO IN 3 IN 2 IN 1 OUT Y PB AV RECEIVER MODEL NO. TX-SR 603X ANTENNA AM VIDEO 3 VIDEO 2 FM 75 VIDEO 1 PR IN 2 ZONE 2 SPEAKERS MONITOR DVD OUT V L R S IN OUT IN OUT IN IN ZONE 2 IN 3 LINEOUT IN OUT IN IN OUT IN OUT IN FRONT SURROUND CENTER L L OUT REMOTE CONTROL R CD TAPE VIDEO 3 VIDEO 2 VIDEO 1 R DVD SUB WOOFER REMOTE SURROUND BACK SPEAKERS SURROUND SPEAKERS FRONT SPEAKERS CONTROL L L R R PRE OUT SUB WOOFER CENTER SPEAKER IN L R AUDIO OUTPUT L R AUDIO OUTPUT L R e.g., DVD player e.g., MD recorder Notes: • If you connect an -compatible Onkyo MiniDisc recorder or CD recorder to the TAPE IN/OUT jacks, for to work properly, you must change the TAPE/MD/CDR display (see page 50). • Push plugs in all the way to make good connections. • Use only cables for connections. No cables are supplied with this AV receiver. • Some AV components have two jacks. You can connect either one to this AV receiver. The other jack is for connecting more -compatible components. • Connect the AV receiver's jack to only Onkyo AV components. Connecting to other manufacturer's AV components may cause them to malfunction. • Some components may not support all functions. Refer to the manuals supplied with your components. 36 Connecting the Power Cord of Another Component The AV receiver has an AC outlet on its rear panel for connecting the power cord of another AV component. The other component's power switch can then be left in the ON position so that it turns on or off when the AV receiver is set to On or Standby. AC OUTLET AC 120V 60 Hz SWITCHED 120W 1A MAX. Caution: Make sure that the capacity of the component that you connect to the AC OUTLET does not exceed the stated capacity (e.g., 120 W). Notes: • Onkyo components with jacks should be con- nected directly to wall outlets, not the AV receiver's AC OUTLET. • The socket type and capacity will depend on the country in which you purchased the AV receiver.