Optoma TX610ST User's Manual - Page 51
The projector stops responding to all controls
UPC - 796435412036
View all Optoma TX610ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Appendices The projector stops responding to all controls If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power. Check that "Keypad Lock" is not activated by trying to control the projector with the remote control. Lamp burns out or makes a popping sound When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the "Replacing the Lamp" section on pages 53-54. LED lighting message Message POWER/STANDBY LED (Green/Amber) Standby State (Input power cord) Amber Power on (Warming) Flashing Green Temp-LED (Red) Lamp-LED (Red) Lamp lighting Green Power off (Cooling) Error (Over Temp.) Steady light No light Error (Fan fail) Error (Lamp fail) Flashing Green Flashing Amber Flashing Amber Flashing Amber Flashing * POWER/STANDBY LED be ON when OSD appears, be OFF when OSD disappears. 51 English