Optoma TX783 User's Manual - Page 56
Lamp Replacement Procedure
UPC - 796435116705
View all Optoma TX783 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Appendices 1 2 3 4 Lamp Replacement Procedure: 1. Switch off the power to the projector by pressing the "Power/Standby" button. 2. Allow the projector to cool down for at least 30 minutes. 3. Disconnect the power cord. 4. Press OPEN and then pull down the lamp cover carefully. 5. Open the lamp cover. 6. Use a screwdriver to remove the 3 screws from the lamp module. 7. Remove the lamp module. To replace the lamp module, reverse the previous steps. 8. Turn on the projector and use "Lamp Reset" after the lamp module is replaced. Lamp Reset: (i)Press "Menu" (ii)Select "Options" (iii)Select "Lamp settings" (iv)Select "Lamp reset (v)Select "On". English 56
E
n
g
l
i
s
h
56
E
n
g
l
i
s
h
56
Appendices
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the “Power/Standby”
button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Press
OPEN
and then pull down
the
lamp cover carefully.
5. Open the lamp cover.
6. Use a screwdriver to remove the
3
screws from the lamp module.
7. Remove the lamp module.
To replace the lamp module, reverse the previous steps.
8. Turn on the projector and use “Lamp Reset” after the lamp module is
replaced.
Lamp Reset: (i)Press “Menu”
(ii)Select “Options”
(iii)Select
“Lamp settings”
(iv)Select “Lamp reset
(v)Select “
On
”.
2
1
4
3