Optoma W460 W460 User Manual - Page 70

APPENDICES PJLink™ supported commands The table below shows commands to control the projector using the PJLink™ protocol. Command Description Remark (Parameter) Command POWR POWR? INPT INPT? AVMT AVMT? ERST? LAMP? INST? NAME? INF1? INF2? INF0? CLSS? Description Power control Inquiry about the power state INPT Input switching Inquiry about input switching Mute control Inquiry about the mute state Inquiry about the error state Inquiry about the lamp state Inquiry about the available inputs Inquiry about the projector name Inquiry about the manufacturer name Inquiry about the model name Inquiry about other information Inquiry about the class information 0 = Standby Remark (Parameter) 1 = Power on 0 = Standby 1 = Power on 2 = Cooling down 3 = Warming up 11 = VGA1 12 = VGA2 13 = Component 14 = BNC 21 = VIDEO 22 = S-VIDEO 31 = HDMI 1 32 = HDMI 2 30 = Video and audio mute disable 31 = Video and audio mute enable 1st byte: Fan error, 0 or 2 2nd byte: Lamp error, 0 to 2 3rd byte: Temperature error, 0 or 2 4th byte: Cover open error, 0 or 2 5th byte: Filter error, 0 or 2 6th byte: Other error, 0 or 2 0 to 2 mean as follows: 0 = No error detected, 1 = Warning, 2 = Error 1st value (1 to 5 digits): Cumulative LAMP operating time (This item shows a lamp operating time (hour) calculated based on that LAMP MODE is LOW.) 2nd value: 0 = Lamp off, 1 = Lamp on The following value is returned. "11 12 21 22 31 32" The projector name set on the NETWORK menu or the ProjectorView Setup window is returned "Optoma" is returned. "XXXXX" is returned. No other information is available. No parameter is returned. "1" is returned. Note: ‡‡ ‡‡ This projector is fully compliant to the specifications of JBMIA PJLink™ Class 1. It supports all the commands defined by PJLink™ Class 1, and the compliance has been verified with the PJLink™ standard specifications Version 1.0. "XXXXX" shown in the above messages are numbers that vary depending on different models. 70 English