Oreck AIRPB User Guide - Page 11

ENGLISH Troubleshooting Service problems that appear to be major can often be solved easily. You can be your own troubleshooter by reviewing this guide. All other servicing should be done by an Oreck authorized service center. Problem Check What to do Unit does not turn on. • Power Cord • Power Button • Front Grill "Check Collector Cell" has turned red. • Top Cover • Truman Cell™ "Check Collector Cell" • Truman Cell™ light is flashing red. Unit does not remove pollutants. Unit sparks, crackles and pops. • Truman Cell™ • Truman Cell™ "Check Odor Absorber" • Odor Absorber light has turned red. Does not remove odor. • Odor Absorber Unit still does not operate properly. • Check all the above points. • Plug in the power cord. • Set power button for desired blower speed. • Reinsert front grill, sliding right until it locks into place. • Top cover should be replaced and slid back to lock. • Wash Truman Cell™. Make sure it is thoroughly clean and dry before reinstalling. • Hold down theAir Revitalizer button until the light blinks three times to reset the timer after cleaning. • Truman Cell™ may need cleaning. Clean Truman Cell™. • Truman Cell™ may not be completely dry. Allow it to air dry longer. • Truman Cell™ may be damaged. Contact Oreck for service. • Wash Truman Cell™. Make sure it is thoroughly clean and dry before reinstalling. • Sparking or popping noise (arcing) can occur when dust particles build up in the Truman Cell™. Gently wipe the cell wires with a dry cotton swab, or clean the entire cell with Assail-a-Cell or soapy water. • If excessive arcing continues after proper cleaning, the cell may be damaged or wet. If damaged contact Oreck for service. • Hold down the Night Light button until the light blinks three times to reset the Check Odor Absorber timer after replacing. • Replace odor absorber if desired. • If the odor absorber is not replaced, remove old odor absorber to turn off "Check Odor Absorber" light. • Vacuum odor absorber with a soft brush attachment if dirty. Do not use any liquids to clean the odor absorber. • Replace odor absorber if desired. • Contact Oreck for service. 11