Oreck Steam-It User Guide - Page 8

ENGLISH Operation Stubborn Stains For removing stubborn stains or embedded grime on hard surfaces, fold and attach the cloth leaving the brushes underneath the powerhead visible. Move the brush sliders so that the brushes appear underneath the powerhead. Move the brushes backwards and forwards over the selected area. NOTE: Do not use the brushes for routine carpet and hard floor cleaning as unnecessary scrubbing may cause damage. The brushes should only be used for removing stubborn stains and grime. Carpet Pile Rejuvenation To rejuvenate flattened carpet pile, remove the cloth and connect the carpet glide base to the powerhead with the steam comb section in place. IMPORTANT! The housing and accessories become hot during operation.Allow the steam cleaner to cool down before changing the accessories. Never open the water tank cap while the steam switch is on. Hard Floor Cleaning Reduce the steam flow to a lower setting by turning the steam control regulator. Use both forward and backward strokes across the floor area. NOTE: When the cloth becomes very wet, let cool, ring out the moisture, use the reverse side or replace with a clean, dry cloth. Attaching an Accessory Accessories can be used on the main body of the steam cleaner by removing the powerhead and then attaching the desired accessory. 1. Press the lock button to remove the powerhead when cool. 2. Attach the desired accessory by aligning the hole in the side of the accessory with the lock button on the main body of the steam cleaner. Ensure the lock button clicks firmly into place. 8