Oregon Scientific WMR86 User Manual - Page 5

E N • Wind direction indicator. Move the direction of the wind indication and verify the icon moves in the same direction . TEMPERATURE / HUMIDITY SENSOR 2. Insert the batteries, matching the polarities (+ / -). 3. Press RESET after each battery change. 4. Close the battery door. NOTE Do not use rechargeable batteries. It is recommended that you use alkaline batteries with this product for longer performance. NOTE Batteries should not be exposed to excessive heat such as sunshine or fire. The battery icon indicator following areas: may appear in the AREA Weather Forecast Area Temperature or Humidity Area Wind Speed / Wind Direction / Wind Chil Area UVI / Barometer / Rainfall Area MEANING Battery in the base station is low. The displayed channel indicates the outdoor sensor for which battery is low. Battery in the wind sensor is low. Battery in the UV / Rain sensor is low. VERIFY CONNECTION Before proceeding to install sensors outside, please verify communication to the base station. WIND SENSOR 1. Press SELECT until the selected area icon is in the upper display area. 2. Press / to select channel 1 and verify a numerical reading. RAIN GAUGE 1. Press SELECT until the selected area icon is in the lower display area. 2. Press MODE until is displayed. 3. Tilt the tipping funnel on the rain gauge several times and verify a numerical reading on the base station. TIP If no reading is displayed for a sensor, press the SEARCH button on the base station to initiate a wireless sensor search. MOUNTING / PLACING OF SENSORS WIND SENSOR NOTE The sensor should be positioned in an open area away from trees or other obstructions. a b Secure the sensor connector in the desired location: Press SELECT until the selected area icon is in the middle display area. a. Align the back of the sensor connector to an existing pole. Secure in place by inserting the ends of the • Wind speed: Gently rotate the wind vane and confirm a numerical reading on the base station, e.g., . U-bolt into the holes on the sensor connector and securing it with washers and bolts. 5