Panasonic AJHDR150 AJHDR150 User Guide - Page 5
Handling Precautions
View all Panasonic AJHDR150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Handling Precautions OThis unit has been designed with foremost emphasis placed on its reliability as a transmission server. However, to prevent accidents in transmission due to breakdown or obstructions, it is requested that the server be used with a system compiled in duplicate. O By having a newly-developed RAID device built in, the system is designed for continuous operation even if one HDD (hard disk drive) unit breaks down. However, to avoid secondary complications, if one HDD unit breaks down, terminate operation immediately and request servicing from your dealer. O The system is designed so that a faulty HDD can be replaced even while continuity is maintained, but normal operation thereafter cannot be guaranteed. Do not replace a HDD during recording or playback. O The system is designed to facilitate data restoration by replacing a faulty HDD with a new one, but backup copies of data on recording tape, etc., should be made so that important contents recorded on the HDD are not lost due to equipment problems, etc. Faulty equipment can be serviced by your dealer but lost contents cannot be restored. O Do not execute recording or playback while data is being rebuilt. If recording or playback is not being executed, the system disk (9GB) can be rebuilt in approximately 10 minutes and data disks (36GB) can be rebuilt in about 1 hour. O Do not use this unit in a vehicle. This may cause injury or result in problems with the hard disk drive or data. O It takes about 3 seconds to switch to REC mode when the REC command is sent in REC CUEUP mode. O When an HDD is loaded onto this system, extra weight is added to the front panel side. Please note this fact and exercise due caution when moving the system. OWhenever a problem occurs with POWER A or POWER B in the power supply unit, be sure to always turn the relevant power supply switch to OFF. $ Precautions for video and audio input/output operations OFor input/output of HD signal from VTR to the server, use a codex unit that is compatible with the server. O Use the AJ-D780 when using the SDTI 4a speed for input/output from a VTR to the server. O When using the SDTI 1a speed for input/output from a VTR to the server, use a VTR mounted with SDTI baseboard such as AJ-D850, AJ-D950 or AJD960. The AJ-D780 does not have a SDTI 1a speed function. OWhen using analog or SDI input/output, signals buried in the video blanking area (e.g., signals for letter broadcasting) cannot be recorded or played back. Recording and playback are possible when a SDTI I/O board is used. 5