Panasonic CF29NTQGZBM CF29L3LGZBM User Guide - Page 39
Appendix
View all Panasonic CF29NTQGZBM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
3 Select the operation to be executed from the menu. 1 Press ç1ççto execute [1. [Backup]]. (When dividing the hard disk into two partitions, select the backup method at next screen.) 2 At the confirmation message, press Y . The backup process will begin. 1 Press ç2ççto execute [2. [Restore]]. (When data is backed up in two partitions, select the restore method at next screen.) 2 At the confirmation message, press Y . The restore process will begin. NOTE The time required to complete the backup or restore process differs depending on the data volume. 4 When the message [[Backup] is complete] or [[Restore] is complete] is displayed, press çCtrlççò çAltççòççDel ç to restart the computer. • If the backup or restore process was interrupted before completion, for example if the power was turned off, execute the process again. • After logging on to Windows, when a new device is installed and a message appears advising that the computer must be restarted to enable the settings, select [Yes] to restart the computer. CAUTION When the hard disk backup function has been enabled, the backed up data will not be erased even if a commercial data erasing utility or similar software is used to erase all data from useraccessible area. To erase all data on the hard disk, including backed up data, use a commercial data erasing utility after disabling the hard disk backup function following the procedure below, or use the hard disk data erase utility included in this computer ( page 40). Occasionally, the message [#1805 cannot write image file] will be displayed, and the backup function will be interrupted. If this error occurs, execute the backup function again. After this, if the backup function is completed properly, then there is no problem in the hard disk. To disable the hard disk backup function Perform the reinstallation procedure. All data in the backup area and the hard disk will be erased. Conduct steps 1-8 for "Reinstalling Software" ( page 32). Select [1] or [2] to execute the reinstallation at the screen for executing the reinstallation. • When [1] is selected, the hard disk backup function will be disabled. • When [2] is selected, the hard disk backup function will be disabled, but in this case, because the hard disk has been divided into partitions, the hard disk backup function cannot be re-enabled ( page 25). 39 Appendix