Panasonic CQ-C5301U CQ5301U User Guide - Page 21

❐ Preparation Warning: If your vehicle is equipped with air bag and/or anti-theft systems, specific procedures may be required for connection and disconnection of the battery to install this product. Before attempting installation of this electronic component, contact your vehicle dealer or manufacturer to determine the required procedure and strictly follow their instructions. FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOYMENT OF AIR BAGS OR ACTIVATION OF THE ANTI-THEFT SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY. • Disconnect the cable from the negative battery terminal (see warning and caution below). • Remove Mounting Collar q from the main unit temporarily, which are already mounted at shipment.* Caution: Various settings that have been stored in the memory in other on-board equipment (vehicle navigation etc.) may be lost if the battery terminals are disconnected. Therefore, we recommend to make a record of or to back up the settings before disconnecting the terminals. After completing installation of the main unit, set the equipment again according to the record. • Unit should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30˚. ❐ Installation Hardware No. Item Diagram Q'ty q Mounting Collar* 1 w Plain washer (5mmø) 2 e Spring Washer (5mmø) 2 r Hex. Nut (5mmø) 2 t Rear Support Strap 1 y Hex. Bolt (5mmø ¥ 25 mm) 1 u Toothed Lock Washer (5mmø) 1 i Removal Tool (U-shaped) 2 (a) Using the rear support strap t ❐ Dashboard Installation Installation Opening This unit can be installed in any dashboard having an opening as shown below. The dashboard should be 3/16" (4.75 mm) - 7/32" (5.56 mm) thick in order to be able to support the unit. (b) Using the rubber cushion (option) Rear support bracket Rubber cushion (option) (provided on the vehicle) Mounting bolt (5 mmø) G Mounting collar 21 CQ-5301U