Panasonic CQ4330U CQ4330U User Guide - Page 8
Alarm Time Setting
View all Panasonic CQ4330U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Alarm Time Setting The 12-hour system is used for the clock. Initial Alarm Time Press and hold [ALM] (Alarm) "AM 12:00" is displayed when the alarm is not adjusted. APM DISP PWR BAND MODE VOL PUSH SEL/SAT BASS/TREB BAL/FADER DISC 1 MTL 2 NR 3 TPS CQ-4330U CD SCAN 4 REP RPT 5 SKP LOUD MUTE RDM SCAN 6 ILL CLK ALM TUNE SEEK [{] (Hours) [}] (Minutes) Alarm Time Setting q Press and hold [ALM] (Alarm) and do not release to set alarm time. Display blinks and the alarm time setting mode is activated. Alarm Operation • Alarm is switched to ON or OFF each time [ALM] is pressed. • When the alarm is switched to ON, the alarm will sound at the set alarm time. (blink.) Hours w Press [{] to set the hour. (Hours set.) Minutes e Press [}] to set the minute. Turning off the Alarm Sound The alarm will turn off automatically after 90 seconds. Otherwise, press [ALM] once. Alarm output Volume Selection You can select ALARM VOL 1 (or VOL 2) by pressing [ALM] in sequence and the display will show as follows. a a OFF (Minutes set.) r Once the alarm time has been set, release [ALM]. Note: Press and hold [{] or [}] to change numbers rapidly. Alarm Time Reset When you want to reset the alarm time, repeat steps q to r. 8 CQ-4330U Cautions: • Be careful not to set wrong alarm time, otherwise, the alarm may sound while driving. • If the alarm is set, be sure to check the set alarm time by pressing [CLK]. • If volume is set at "0" level, the output volume will be muted. (Even when ALARM is acting.)