Panasonic CQ5100U CQ5100U User Guide - Page 19
Connect the battery cable to the terminal that is always active., quality. e.g. caused
View all Panasonic CQ5100U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
❐ Radio Trouble Much noise in FM stereo and monaural broadcasts. Preset station is reset. ❐ CD Trouble Disc is in the CD compartment but no sound is made, or disc is ejected automatically. Sound skips, bad sound quality. (e.g. caused by noise) Sound skips due to vibration. Check point Station is too far, or signals are too weak. a Select other stations of higher signal level. The radio antenna is not extended enough. a Extend fully the radio antenna. Battery cable is not correctly connected. a Connect the battery cable to the terminal that is always active. Check point Disc is upside down. a Place disc in the correct direction with the label side up. • Disc is dirty. • Disc has scratches. a Clean disc, referring to the section on "Notes on Discs". A disc that has data other than CD-DA type is loaded. a Discs that have CD-DA type data should be used. a The unit may not successfully playback a CD-R/RW that is made in combination of writing software, a CD recorder (CD-R/RW drive) and a disc which are incompatible one another. Refer to instructions for the concerned devices for details. • Disc is dirty. • Disc has scratches. a Clean disc, referring to the section on "Notes on Discs". a The unit may not successfully playback a CD-R/RW that is made in combination of writing software, a CD recorder (CD-R/RW drive) and a disc which are incompatible one another. Refer to instructions for the concerned devices for details. Mounting angle is over 30˚. a Adjust mounting angle to less than 30˚. Instable mounting. a Mount the unit securely with the mounting parts, referring to the section on installation. 19 CQ-5100U