Panasonic CQ5300U CQ5300U User Guide - Page 17

Press and hold ቢ d l Alarm Time Setting ቢ Press and hold [ALM] to set alarm time. Display blinks, and the alarm time setting mode is activated. Press [i] to set the hour. Press [j] to set the minute. (Hold [i] or [j] to change numbers rapidly.) ባ When you have set the alarm time, release [ALM]. Note: When the alarm is not set yet, "AM 12:00" is displayed. ቢ FEW k 5500U or l ቢ FEW k 5500U Alarm Time Reset To reset the alarm time, repeat steps ቢ and ባ above. ባ Alarm Operation Alarm is switched to ON or OFF each time [ALM] is pressed. When the alarm is switched to ON, the alarm will sound at the set alarm time. Turning off the Alarm Sound The alarm will turn off automatically after 90 seconds. Otherwise, press [ALM] once. Alarm output Volume Selection You can select ALARM VOL 1 (or VOL 2) by pressing [ALM] in sequence and the display will show as follows. ALARM TIME a ALM VOL 1 a ALM VOL 2 (display 3 seconds) (display 2 seconds) (display 2 seconds) OFF Cautions: Be careful not to set wrong alarm time, otherwise, the alarm may sound while driving. If the alarm is set, be sure to check the set alarm time by pressing and holding [ALM] for more than 2 seconds. If volume is set at "0" level, the output volume will be muted. (Even when ALARM is acting.) 16