Panasonic DMP-BDT270 Owners Manual - Page 29
Picture, The images from this unit do not appear
View all Panasonic DMP-BDT270 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Reference You have forgotten your ratings password. You want to cancel the ratings level. ¾ The ratings level returns to the factory defaults. 1 Turn the unit on. 2 Press and hold [OK], the yellow button and the blue button on the remote control at the same time for more than 5 seconds. - POWER LED starts to flash, and "00 RET" is displayed on the screen. 3 Press [1] (right) repeatedly on the remote control until "03 VL" is displayed on the screen. 4 Press [OK]. The TV screen turns black. ¾ In the following cases, HDMI authentication takes place and a black screen is displayed: - [BDT270] When "24p(4K)/24p Output" is set to "24p(4K)" or "24p". - [BD903/93] When "24p Output" is set to "On". - [BDT270] When the display is switched between 2D and 3D images. This unit does not recognize the USB connection correctly. ¾ Disconnect and re-connect the USB cable. If it still does not recognize the connection, turn this unit off and on again. ¾ USB devices may not be recognized by this unit when connected using the following : - a USB hub - a USB extension cable ¾ If you connect USB HDD to this unit, use the USB cable that is supplied with the HDD. Picture The images from this unit do not appear on the TV. Picture is distorted. ¾ An incorrect resolution is selected in "HDMI Resolution". Reset the setting as follows: 1 Turn the unit on. 2 Press and hold [OK], the yellow button and the blue button on the remote control at the same time for more than 5 seconds. - POWER LED starts to flash. 3 Press [8] and the blue button on the remote control at the same time for more than 5 seconds. Set the item again. (> 23) - When Dolby Digital Plus, Dolby TrueHD, and DTS-HD® audio are not output properly, select "Yes" in "Restore Default Settings" (> 27) and make proper settings. ¾ [BDT270] When "3D BD-Video Playback" in the Setup menu is set to "Auto", images may not be output depending on the connection method. After removing the disc from this unit, select "Set before play" in the Setup menu, and select "2D Playback" in the setup screen displayed when playing 3D discs. (> 25) ¾ [BDT270] When outputting in 24p (4K), images may be distorted depending on the HDMI cable. Use an HDMI cable that supports 4K output. Video is not output in high-definition. ¾ Confirm that "HDMI Resolution" in the Setup menu is set properly. (> 23) [BDT270] 3D video is not output. ¾ Connect to a full high-definition TV. ¾ Is there a non-3D compatible amplifier/ receiver connected between this unit and a TV? (> 10) ¾ Are the settings on this unit and the TV correct? (> 17) ¾ Is the amplifier/receiver that is connected between this unit and TV on? ¾ Depending on the connected TV, the video being played back might switch to 2D video due to changes in resolution etc. Check the 3D setting on the TV. - 29 -