Panasonic DMRE75VP DMRE75VP User Guide - Page 12

Before Use Connecting amplifier or system component ∫ To enjoy multi-channel surround sound on DVD-Video (digital connection) Connect an amplifier with a built-in decoder with these logo marks. ≥Use an optical digital audio cable. ≥Change the settings in "Digital Audio Output" (l 44). ≥You cannot use DTS Digital Surround decoders not suited to DVD. ≥Even if using this connection, output will be only 2 channels when playing DVD-Audio (1) (1) Rear panel of this unit (2) Insert fully, with this side facing up. (Do not bend when connecting.) (3) Optical digital audio cable (not supplied) (4) To optical digital input (5) Amplifier's rear panel Y PB PR R - AUD COMPONENT VIDEO OUT (480P/480I) OPTICAL DIGITAL AUDIO OUT (PCM/BITSTREAM) R - AUD DVD OUT (2) (3) OPTICAL IN (5) (4) Dolby Digital (l 44) This is a method of coding digital signals developed by Dolby Laboratories. Not only stereo (2 channel) audio, these signals can also be 5.1-channel audio. A large amount of audio information can be recorded on one disc by this method. DTS Digital Surround (l 44) This surround system is used in many movie theatres around the world. The separation between channels is good and the compression ratio is low, so realistic sound effects are possible. DTS sound tracks are produced with the assumption that all channels will be used. ∫ Connection to a stereo amplifier (analog connection) (1) Rear panel of this unit (2) To AUDIO OUT (L/R) (3) Audio cable (not supplied) A Red (R) B White (L) (4) Audio input (L/R) (5) Amplifier's rear panel (1) PB PR COMPONENT VIDEO OUT (480P/480I) OPTICAL DVD/VHS COMMON OUT R - AUDIO - L VIDEO (2) ITAL AUDIO OUT CM/BITSTREAM) R - AUDIO - L DVD OUT VIDEO S-VIDEO (3) DVD output and DVD/VHS output This unit has DVD/VHS COMMON output terminals which are common to both DVD and VHS, and DVD output terminals which are exclusively used for DVD. DVD/VHS COMMON output Y PB PR DVD/VHS COMMON OUT R - AUDIO - L VIDEO COMPONENT VIDEO OUT (480P/480I) OPTICAL DIGITAL AUDIO OUT (PCM/BITSTREAM) R - AUDIO - L DVD OUT VIDEO S-VIDEO R - AUDIO DVD output ≥For DVD/VHS COMMON output terminals, both DVD and VHS outputs can be switched. ≥The DVD output terminals can only output the DVD signal. ≥Even if "Automatic" is selected in "DVD/VHS Output" on "Set Up" Menu (l 43), the desired output may not be selected depending on the operation. In this case, press [DVD/VHS OUTPUT] on the remote controller to switch manually. ≥When the Video is switched from DVD to VHS or vice versa, the audio volume may suddenly increase or decrease. This is because when the audio output of this unit is connected to the TV or other, the audio output of the DVD is generally lower. When you increase the volume level of the TV or the amplifier to play back DVD audio, reduce it when playback is finished. R L AUDIO IN (5) (4) Preparation ≥Press [DVD]. [1] While stopped Press [FUNCTIONS]. (l 47) [2] Select "SETUP" with [3, 4, 2, 1] and press [ENTER]. [3] Select "Set Up" with [3, 4] and press [2, 1]. [4] Select "DVD/VHS Output" with [3, 4] and press [ENTER]. [5] Select "Automatic" or "Manual" with [3, 4] and press [ENTER]. 12