Panasonic DMREA38V Dvd Recorder - Multi Language - Page 76
General Issues, Operation
View all Panasonic DMREA38V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Troubleshooting Guide General Issues Operation Cannot operate the TV or Set Top Box with the unit's remote control. Cannot operate the DVD. Cannot operate the VHS. The remote control doesn't work. The unit is on but cannot be operated. "U88" is displayed and the disc cannot be ejected. Cannot eject a disc. Startup is slow. Cannot set "24p Output for DVDVideo". Make necessary settings for the Set Top Box Control. Change the manufacturer code on the remote control. Select TV or Set Top Box mode on the remote control. Press [DRIVE SELECT] to select the DVD drive when operating DVDs or CDs. - Make sure the TV is on the correct channel or input mode. Press [DRIVE SELECT] to select the VHS drive when operating VHS cassettes. - Make sure the TV is on the correct channel or input mode. The remote control code is wrong. Change to the correct code. The batteries are depleted. Replace them with new ones. Point the remote control at the remote control sensor on the main unit. Remove obstacles between the remote control and main unit. Remove dust from the transmission window and the unit's sensor. Colored glass may obstruct the signal reception/transmission. Don't place the signal sensor in direct sunlight or in areas that may be subject to sun exposure. It may be necessary to set the code on the remote control again after changing the batteries. It may be necessary to set the manufacturer code again after changing the batteries. Some operations are prohibited by the disc. The unit is warm ("U59" appears on the unit's display). Wait until "U59" disappears. One of the unit's safety devices may have been activated. Reset the unit as follows: Press [/I POWER] on the main unit to switch to off. If the unit doesn't switch to off, reset the unit ( 74, "To restore the unit if it freezes"). The unit is carrying out the recovery process. Do the following to eject the disc: (1)Press [/I POWER] on the main unit to switch to off. If the unit doesn't switch to off, reset the unit ( 74, "To restore the unit if it freezes"). (2)While the unit is off, press and hold [] and [INPUT SELECT] on the main unit at the same time for about 5 seconds. (Ejection may take extra time depending on discs.) The disc may be defective. Try another disc. The unit is recording. The unit may have a problem. Eject the disc as in (2) above. Startup takes time in the following situations: - A disc other than a DVD-RAM is inserted. - The clock is not set. - Immediately after a power failure or the AC power supply cord is connected. - When the unit is connected with an HDMI cable. Only when the unit is connected to the HDMI terminal of a TV supporting 24p, you can set "24p Output for DVD-Video". In some cases where the unit is connected to a TV via an amplifier/receiver through the HDMI terminals, you may not be able to set it. In this case, connect the unit to a TV through the HDMI terminal and connect it to the amplifier/receiver through any terminal other than HDMI. Page 52 61 61 14 15 53 5 5 53 61 − − − − − − − 59 76 RQT9058