Panasonic EP30007 Massage Chair - Page 15
Attaching the control panel stand to the right or left side panel of the unit, Attaching the control
UPC - 952387000459
View all Panasonic EP30007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3 Attaching the control panel stand to the right or left side panel of the unit (Diagram shows attachment to right armrest.) 1. Insert the attachment screw into the lower hole first and then tighten lightly by hand. 2. Securing the stand with the attachment screws. Tighten the two screws for the remaining two holes lightly by hand and then tighten firmly with the allen key. The position of the control panel when seated can be selected by choosing the appropriate hole for the screw. Near Approx. 20˚ Far Control panel stand 1 Insert the attachment screw in either hole and then tighten. Attachment screw Use this screw Attachment Screw (M6 × 16) × 3 2 Allen key To attach the control panel stand using the attachment screws, tighten the screws level with the holes as shown in the figure below. If the screws are tightened at an angle, the hole may become deformed and the screws may become stuck in the middle. Control panel Control panel stand stand Hole Attachment screw Hole Allen key Tighten the screws level with the holes. Attachment screw Allen key Do not tighten the screw at an angle with the hole. 4 Attaching the control panel stand covers (On both the right and left sides) The method for attaching the covers is the same for both sides. The diagram shows the side where the control panel stand is attached. Cover for Side WITH Cover for Side WITHOUT Control Panel Stand Control Panel Stand 1. Insert the top tabs on the cover into the bottom notches on the armrest. Notches 2. Insert the bottom tabs into the notches on the armrest. Bottom tabs Top tabs Control panel stand cover Notches Push the cover until you hear it click. 12