Panasonic EY7410 EY7410 User Guide - Page 8

has a negligible effect on the operational capacity of the drill. ● The LED is incapable of lighting the tip of the bit when the drill is used in the straight configuration.  Bit-locking Function With the switch at off and the bit lock­ ed in place, the tool can be used as a manual screw-driver - up to 14.7 N·m (150 kgf-cm, 130 in-lbs). There will be a little play in the driving shaft, but this is not a malfunction. Speed selection LOW 200 /min (rpm) HIGH 600 /min (rpm) Torque High Low CAUTION: • Check speed selector switch before use. • Do not operate the speed selector switch while the main switch is on (switch is in the ON position).  Main Switch Lock After use, set the main switch lock at the lock position to prevent accidental operation. Main switch lock Lock  Main Switch (ON/OFF) Push the upper half of the switch for forward rotation, or the lower half for reverse rotation. Forward Forward Reverse Reverse  Battery Pack (EY9L10) CAUTION: 1. Remove the battery pack away from the tool. 2. Charge the battery pack using the battery charger. 3. After charging has been completed, remove the battery pack from the charger and connect it to the tool. Disconnect the charger from the power source when not in use.  Speed Selector Switch To suit the application of this tool, two different rotational speeds are available. Depending upon use, either the high or low speed should be selected. HIGH LOW NOTE: Use under extremely hot or cold conditions will reduce operating capacity per charge. -  -