Panasonic EYFEA1N EYFEA1N User Guide - Page 9
Switch and Forward/Reverse, Lever Operation, Forward Rotation Switch, Operation, Reverse Rotation
View all Panasonic EYFEA1N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Switch and Forward/Reverse Lever Operation CAUTION: Set the clutch scale at the alignment position before actual operation. Forward Reverse Switch lock CAUTION: To prevent damage, do not operate Forward/Reverse lever until the bit comes to a complete stop. Forward Rotation Switch Operation 1. Push the lever for forward rotation. 2. Depress the trigger switch slightly to start the tool slowly. 3. The speed increases with the amount of depression of the trigger for efficient tightening of screws and drilling. The brake operates and the chuck stops immediately when the trigger is released. 4. After use, set the lever to its center position (switch lock). Reverse Rotation Switch Operation 1. Push the lever for reverse rotation. Check the direction of rotation before use. 2. Depress the trigger switch slightly to start the tool slowly. 3. After use, set the lever to its center position (switch lock). Setting Torque Use 1 Approx: 0.3 N·m (3.0 kgf-cm or 2.6 in-lbs) 5 Approx: 1.0 N·m (11 kgf-cm or 8.8 in-lbs) 9 Approx: 1.8 N·m (18 kgf-cm or 15.9 in-lbs) For driving 13 Approx: 2.5 N·m (26 kgf-cm or 22.1 in-lbs) screws 17 Approx: 3.3 N·m (33 kgf-cm or 29.2 in-lbs) 21 Approx: 4.0 N·m (41 kgf-cm or 35.4 in-lbs) Approx: 6 N·m (61 kgf-cm or 53.1 in-lbs) For powerful driving screws and drilling ●● When using at high speeds, set the clutch at 10 or below. (Operation stops at the maximum torque of 1.5 N·m (15 kgf-cm) when the scale is higher.) ●● The auto shut-off function may become inoperable at high clutch settings when battery power drops. Recharge the bat- tery in that case. Speed Selection Choose a low or high speed to suit the use. HIGH LOW Clutch Torque Setting Adjust the torque to one of the 21 clutch settings or " " position. The more the variable speed control trigger is pulled, the higher the speed becomes. Use for Drilling ●● When using for drilling, set the clutch at " " position. ●● Use a bit designed for drilling. CAUTION: ●● Check the speed selector switch be- fore use. - 9 -