Panasonic FV-08WQ1 Installation Instructions - Page 8
Installation, In remodeling - continued
View all Panasonic FV-08WQ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation II (In remodeling)- continued 7. Insert the attached exterior hood from the outside to cover the wall sleeve, and secure it with four screws or nails. Cover the seam between the wall sleeve and exterior hood with mastic tape and apply mortar or caulking to prevent rainwater from penetrating into the stud cavity. (Fig. 13) Try to leave as much insulation in place as possible to help prevent condensation from forming. Insulation around ducts can reduce energy loss and inhibit mold growth. 8. Pull the flexible conduit through the hole where the junction box was attached to the wall sleeve. (Fig. 14) 9. Remove the knockout hole in the junction box and secure one end of the flexible conduit to the junction box. mastic tape Seam Exterior hood Finish with mortar or caulk. Fig. 13 Wiring Diagram White Motor Black Red Green Switch (Available on Junction box the market) Power supply AC 120 V 60 Hz Green Earth ground 10. Refer to the wiring diagram above. Using the wire nuts, connect the house power wires to ventilating fan wires. (Fig. 4 on page 5): black to black; white to white; green to greens. 11. Place the junction box in its original position in the wall sleeve and reattach the box cover. (Fig. 15) Flexible conduit Fig. 14 CAUTION: Reattach the junction box cover carefully so that the lead wires are not pinched by the cover. 12. Remove the grille from the fan unit. (Fig. 8 on page 6) 13. Attach the electrical connectors to each other, hook the frame latches onto the mounting plate latch, and secure the fan unit to the mounting plate with the supplied screw (screw III). (Fig 16) 14. Reattach the grille to the frame. CAUTION: Press on the grille until it clicks. NOTE: Be sure to paint the exterior hood. Before painting, thoroughly wipe off any oil on the surface. Also make sure that the paint does not enter inside of the hood. Latch Latch Fig. 15 Mounting plate Frame Grille Fig. 16 8