Panasonic FV08VS1 FV08VKL1 User Guide - Page 11

INSTALLATION VI ( IN EXISTING CONSTRUCTION ) 1. Installation in existing construction. Installing the fan body in an existing building requires an accessible area (attic or crawl space) above the planning installation location or existing ducting and wiring. (1) To install the fan body, follow the procedures described in Installation II. Take the following precautions before installation. CAUTION: Check area above planning installation location to be sure that: 1. Duct work can be done and that area is sufficient for proper ventilation. 2. Wiring can be run to planning location. 3. No wiring or other obstructions shall interfere with installation. (2) Inspect duct work and wiring before proceeding with installation. (3) Plan suitable location for fan body. (next to ceiling joist) (4) Before installation, provide inspection and maintenance access at a location that will not interfere with installation work shown in installation II. (5) First, remove ceiling section. (6) Install fan body. 2. Installation from accessible area above fan location. (1) Inspect duct work and wiring before proceeding with installation. (2) Remove ceiling section. (3) Install fan body. MAINTENANCE I (CLEANING) WARNING: Disconnect power source before working on unit. Routine maintenance must be done every year. \ _.----- Slot Mounting spring CAUTION: 1. Never use gasoline, benzene, thinner or any other such chemicals for cleaning the ventilating fan. 2. Do not damp water to motor. 3. Do not soak resin parts in water over 60°C. 1. Remove grille. (Squeeze mounting spring and pull down carefully.) (Fig. 22) 2. Wash and clean grille. (Use non-abrasive kitchen detergent, wipe dry with new cloth.) (Fig. 23) Gloves Grille 4 Fig. 22 Fig. 23 3. Remove dust and dirt from fan body using a vacuum cleaner.(Remove lamps if necessary.) (Fig. 24) 4. Using a cloth dampened with kitchen detergent, remove any dirt from fan body. Wipe dry with new cloth. (Fig. 25) 5. Replace lamps and grille. ---Vacuum cleaner --- Fig. 24 Fig. 25 11