Panasonic HDC-HS900 Owners Manual - Page 48

[QUICK POWER ON] [OFF]/[ON] The unit is put into recording pause approx. 1 second when the unit is turned on with the mode set to or . ≥ Depending on the recording conditions, start time may be longer than 1 second. ≥ In the Quick power on mode, the zoom magnification becomes 1k. [QUICK START] [OFF]/[ON] This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened or the viewfinder is extended. ≥ When in Quick start standby mode about 80% of the power used in Recording pause mode is being consumed, so the recording time will be reduced. ≥ Quick start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there is no SD card inserted. ≥ Change the mode to or . 1 Set [QUICK START] to [ON]. 2 Close the LCD monitor and retract the viewfinder while the mode is set to or . The status indicator A flashes green and the unit goes into Quick start standby mode. ≥ The lens cover does not close. 3 Open the LCD monitor or extend the viewfinder. The status indicator A lights red and the unit is put into recording pause. ≥ Quick Start Standby Mode is canceled if j about 5 minutes have elapsed j mode is set to ≥ Depending on the recording conditions and menu settings, time for Quick start may be longer than 0.6 seconds. ≥ It may take some time for Automatic white balance to adjust. ≥ In the Quick Start Mode, the zoom magnification becomes 1k. ≥ If [ECONOMY] (l 47) is set to [5 MINUTES] and the unit automatically goes into Quick Start Standby Mode, close the LCD monitor and viewfinder and then open the LCD monitor or extend the viewfinder again. ≥ Turn the unit off using the power button. ≥ Quick start standby mode cannot be released by the remote control. [REMOTE CONTROL] [OFF]/[ON] Please refer to page 53. 48 VQT3K69