Panasonic HMC70 Memory Card Camera Recorder - Page 111
Troubleshooting, Unit operations
UPC - 791871303429
View all Panasonic HMC70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Others Troubleshooting ª Unit operations Problem This unit cannot be turned on. This unit is turned off automatically. This unit does not stay on long enough. A clicking sound is heard when the unit is shaken. Battery runs down quickly. The minute display of the remaining battery power indication is not displayed correctly. Check points ≥Is the battery fully charged? # Charge it with the AC adaptor. (l 29) ≥The battery protection circuit may have operated. Attach the battery to the AC adaptor for 5 to 10 seconds. If the unit still cannot be used, the battery is faulty. ≥Did you set the power save function to [5 MINUTES]? # If the power save function is set to [5 MINUTES], then when the camera is not operated for approximately 5 minutes, the power is automatically shut off to save the battery. To resume recording, turn the power back on. The power will not turn off automatically when the power save function (l 104) is set to [OFF]. ≥Is the battery low? # If the remaining battery power indication is flashing or the message "LOW BATTERY." is displayed, the battery has run down. Charge the battery. (l 29) ≥This is the sound of the lens moving and is not a defect. This sound will no longer be heard when the unit's power is turned on. ≥Is the battery fully charged? # Charge it with the AC adaptor. (l 29) ≥Are you using the battery in an extremely cold place? # The battery is affected by ambient temperature. In cold places, the operating time of the battery becomes shorter. ≥Has the battery worn out? # The battery has a limited life. If the operating time is still too short even after the battery is fully charged, the battery has worn out and can no longer be used. ≥The remaining battery capacity indication is an approximation. If you think the remaining battery capacity indication is not displayed correctly, fully charge the battery, discharge it and then charge it again. (Even if this operation is performed, it may not be possible to display the remaining battery capacity correctly if the battery was used for a long period of time where the temperature was low or high or if the battery was repeatedly charged.) 111