Panasonic HX-A1M Basic Owners Manual - Page 16

Turning this unit on/off

Page 16 highlights

2 Insert (remove) the microSD card into (from) the card slot. ≥ Insert the microSD card with its terminal side facing down. Push it straight in until it clicks into place as shown in the figure. ≥ Press the center of the microSD card and then pull it straight out. 3 Rotate the terminal cover in the opposite direction of Step 1 to attach it. ≥ Tighten it firmly to ensure that it is not loose. Preparation Turning this unit on/off Press the power button to turn on this unit. The power lamp is turned on. To turn off this unit Press and hold the power button for approximately 1 second. ≥ The power lamp goes off after a while. About overheat detection If the internal temperature of this unit rises during use, warning beeps will be heard and the power lamp will flash fast. This unit will then turn off automatically. To use this unit again, wait until it cools down. ≥ This unit cannot be used until it cools down. About battery level indications You can check the battery level by looking at the recording mode lamps when you have turned on this unit. Battery level 100% to 76% 75% to 41% 40% to 21% 20% or less Recording mode lamps ≥ The battery level can be checked for a few seconds after this unit has been turned on. 16 SQT0885 (ENG)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42

16
SQT0885 (ENG)
2
Insert (remove) the microSD card into (from) the card slot.
Insert the microSD card with its terminal side facing down. Push it straight in until it clicks into
place as shown in the figure.
Press the center of the microSD card and then pull it straight out.
3
Rotate the terminal cover in the opposite direction of Step 1 to attach it.
Tighten it firmly to ensure that it is not loose.
Press the power button to turn on this unit.
About overheat detection
If the internal temperature of this unit rises during use, warning beeps will be heard and the power
lamp will flash fast. This unit will then turn off automatically. To use this unit again, wait until it cools
down.
This unit cannot be used until it cools down.
About battery level indications
You can check the battery level by looking at the recording mode lamps when you have turned on
this unit.
The battery level can be checked for a few seconds after this unit has been turned on.
Preparation
Turning this unit on/off
The power lamp is turned on.
To turn off this unit
Press and hold the power button for
approximately 1 second.
The power lamp goes off after a while.
Battery level
100% to 76%
75% to 41%
40% to 21%
20% or less
Recording mode lamps